Niutuo Cordless Wall Paint Sprayer Airless Spray Gun Aluminum Pot 1000ml For Makita 21veu

Specification Product Name: Wireless Lithium Electric Spray Gun Brand: Hengpeng Voltage: 2000mAh Load power/electricity: 21V/2.0A Working pressure: 15kpa Nozzle: 10/15/1.8/2.0/2.5 copper nozzle Watering can: aluminum alloy/1000ml Maximum flow: 0-1200ml/min Paint Density ...Specification Product Name: Wireless Lithium Electric Spray Gun Brand: Hengpeng Voltage: 2000mAh Load power/electricity: 21V/2.0A Working pressure: 15kpa Nozzle: 10/15/1.8/2.0/2.5 copper nozzle Watering can: aluminum alloy/1000ml Maximum flow: 0-1200ml/min Paint Density Requirements: 100s Noise figure: <92dB Vibration index: 1.82m/s2 Insulation Type: Back (Double Insulation) Endurance time: 10-25min Charging time: 2 hours Product size: 310*270*140mm Tips for measuring viscosity: Make sure you can use mineral spirits or paint thinner (for oil-based paints) or a warm water and soap solution (for water-soluble paints like latex) to clean the type of paint you are using for spray paint mixing and viscosity testing , to protect your floors and any other items in the sprayed area that you want to keep intact. Before starting to spray, the paint needs to be diluted. warn Do not use paints with a flash point higher than 600C (1400F).

A viscosity test CUP is provided to determine the "run-up time" of the coating used Thoroughly stir the paint before measuring the proper viscosity. Dip the viscosity cup into the paint to be sprayed and fill it completely. Hold the cup on the paint container and measure the time it takes for the outflow paint to flow continuously (70 seconds or less) from the bottom of the cup.

Latex paints can be sprayed with this machine, but the required dilution may exceed the paint manufacturer's recommendations. Diluted latex paints should pass through the viscosity cup within 70 seconds, and when spraying, the operator should consider the type of application and final location of paints that require more than 70 seconds to pass through the viscosity cup. Paint type Viscosity cup dripping time (seconds) Oil based paint: 25-45 Oil based primer: 30-50 Water-based paint: 20-35 Water based primer: 25-40 Varnish: 20-55 Solvent based primer: 20-40 Solvent based paint: 15-40 Car paint: 20-35 Latex paint: 20-40 Colorants: No dilution required Wood preservatives: Plant protectants do not need to be diluted Oil-based or water-based paint, primer, topcoat dilution: 5-10% Note: The flash point of paint is above 21.

Always stir and filter the paint thoroughly before preparing the tip for use. When spraying work, always make sure that you have prepared the sprayed surfaces to the best possible finish, i.e. all surfaces are free of dust, rust and grease, make sure to keep them dry before spraying.

Even if the electric sprayer sprays very little, it is recommended that you cover all edges and other areas, and use a rag to protect the floor and anything in the sprayed area. The paint may clog the machine, so filter it with a funnel before spraying to remove impurities that may clog the nozzle. Before you start, have gloves, paper towels, rags, etc.

ready to prevent accidental spills. Always stir and filter the paint thoroughly before preparing the tip for use. When spraying work, always make sure that you have prepared the sprayed surfaces to the best possible finish, i.e.

all surfaces are free of dust, rust and grease, make sure to keep them dry before spraying. Even if the electric sprayer sprays very little, it is recommended that you cover all edges and other areas, and use a rag to protect the floor and anything in the sprayed area. The paint may clog the machine, so filter it with a funnel before spraying to remove impurities that may clog the nozzle.

Before you start, have gloves, paper towels, rags, etc. ready to prevent accidental spills. The on/off trigger presses the trigger, and the trigger will trigger the switch inside the tool through the switch trigger lever to open the tool.

Release the horn to close the tool. Adjust the spray pattern There are three spray patterns to choose from: Horizontal shape Vertical shape Dot shape . Spray Flow Adju