PU SG Coloured Coating

Do you want to refurbish an existing PU or epoxy screed? Do you regret picking your current colour screed? Then this coloured polyurethane topcoat is the perfect solution! Quartzline Coating PU SG Coloured is a two-component silk gloss polyurethane-based topcoat. The coloured ...Do you want to refurbish an existing PU or epoxy screed? Do you regret picking your current colour screed? Then this coloured polyurethane topcoat is the perfect solution! Quartzline Coating PU SG Coloured is a two-component silk gloss polyurethane-based topcoat. The coloured polyurethane coating is water-based and has good abrasion resistance.

The bacteriostatic properties are characteristic of the smooth coating. This means that microorganisms cannot multiply on the Coating PU SG Coloured. For this reason, this coating is widely used in hospitals and laboratories.

Benefits Easy to clean. Aliphatic, so it does not yellow. High abrasion resistance.

Low VOC level in conformity with AgBB. Directions for use This PU topcoat is easy to use. Just follow the instructions below or read the technical documentation.

Before use, sand the surface with 220-grit paper. While mixing, add part B to part A. Mix continuously for a minimum of 3 minutes until a uniform mixture has been achieved.

Let it pre-react for 10 minutes. To ensure thorough mixing and to prevent unmixed parts collecting on the side and/or bottom, pour the materials through a sieve into a clean second container and mix again briefly. Do not pour the coating over the floor, but pour a small amount into a paint bucket.

Work 'wet on wet', but avoid puddles. Use a velor paint roller to apply the coating. Roll the roller into the paint tray and smooth until it no longer drips.

Roll crosswise to spread the topcoat evenly over the floor. Do not apply the coating in too large areas to prevent drying. Work structured and paint area by area to avoid streaks.

With this coating it is difficult to see where you have already painted. Specifications Contents: 1 kg, 2.5 kg and 5 kg Gloss: silk gloss Mixing ratio: 91:9 (weight) Processing time: 30 minutes (20°C) Application method: velor paint roller Dust-dry: 2 hours (20°C) Can be walked on: 24 hours (20°C) Slightly loadable: 48 hours (20°C) Full cure: 7 days (20°C) Processing temperature: 10°C - 25°C Humidity: max. 70% R.H.

Consumption: 150 gr/m² Viscosity: ⁴⁵⁰-⁵⁵⁰ mPa.S Solid content: ³⁹ Pot life: ⁶ months